#DIYGearChallenge @Awesomein360's Helmet 180º Swivel Mount🔥🔥🔥
Hello insta 360 creators! Here I come again with another simple #DiyGear this time dedicated to Motorcycle Riders (or any creator that uses helmets) 🔥🔥🔥 The previous DIY gear showed you how to create a 5 meters #GojiraMonopod but this DIY there's no need of glue and stuff, just good and sturdy aluminium materials, the best for 360 as plastic is a No-Go to secure our precious cameras 🤙 In this DIY gear project I will gather the tools to create a 180º swivel where we can attach our 360 camera. All you need is to get: One screw mount (swivel) (This is the most important acessory) Two aluminium sections of the unicorn mount + 1 thumb screw (or a 4mm hex screw) One 1/4 mount with spacer + thumb screw
(Swivel mount)
(180 Swivel mount set-up with 1 unicorn extension)
All these accessories will cost less than 15$ if bought in the internet or less if you already have some of them.
The swivel mount is screwed into the helmet's already existing screw holes that support either the visor or peak (on my helmet it's the central screw that holds the peak) The screw might have to be sawed to the right hole length or you can buy a smaller length 5mm screw It Will work with a invisible selfie stick too but the added weight is not confortable when riding because the wind resistance is higher and so it will be the stress given to the screw holes.
(Full Set-up mounted on the Helmet with 2 unicorn extension)
Here I share two videos recorded with this 180º swivel mount, one of them already known for some of you
(Video shot for this DIY gear Challenge)
(Master Dolly Zoom Effect Tutorial)
👇👇👇👇
https://forums.insta360.com/mobile/section/16/post/6924/
I hope you enjoy assembling this #DiyGear and if you found it valuable, hit that 👍 and favourite 🌟 for future reference
A lot of Awesomein360 content is continuously coming and more DIY gear is included!
Follow me here, in insta360 and on the usual social media platforms (my username is the same).