#DIYGearChallenge - @Awesomein360's 3M DashCam mount

Hello insta 360 creators!

Here I come again with another simple #DiyGear this time dedicated to a Dashcam mount allowing you to easily get a solution to take Incredible hyperlapses, time shifts, flylapses, etc🔥🔥🔥

So, in this #DIYgear project I will show you how easy it is to add a Dashcam mount to your vehicle.

What you will need:

Having in mind that the One R weighs around 150grs, all you need is 3M mushroom double lock tape (more advanced and stronger than velcro) and a 1/4 inch screw or hot shoe mount from your photography gear or photography store like this:

I also use a second washer to tighten up better.

If you have at least 3 batteries you can actually glue this 3M tape onto one of the batteries base and you won't even need to use the cage making it even lighter and less prone to oscillations.

The down side is that it may be too low in some vehicles.

Here is an example captured with the 3M dash cam mount:

Pro tip: apply the stickers on both surfaces a few days before starting to use them.

The sticker strength becomes stronger after sitting down for a few days.

I hope you enjoy doing this #DiyGear and if you found it valuable, hit that 👍 and favourite 🌟 for future reference.

A lot of awesomein360 content will continue coming and more DIY gear is included too as I'm going to start shooting with the X2 🔥🔥🔥🔥

Follow me here in insta360 and on the usual social media platforms (my username is the same).

Keep creating 💫

Keep chasing adventure💛

Thank you everyone for being passionate about 360✌️✌️

Stay @Awesomein360 🤙🤙